Valve for use in power generation plants, municipal water treatment and industrial applications

Features

• Face to face is in compliance with EN558, series 13 (short) and 14 (long) for sizes below DN 2000. Sizes DN 2000 and above face to face is according to AWWA C516.
• Replaceable actuator flange in accordance to ISO 5211.
• Cast double flanged butterfly valve, which can be drilled acc. various flange standards (JIS, BS, ISO/EN, ASME and AWWA). Dead-end service capability with down stream piping removed.
• Body and disc protective coatings or rubber linings are available for sea water or corrosive services.
• Low headloss thru optimized disc design.
• The special seat and disc edge contours reduce seating torque, provide better shut-off and longer service life.
• The seat is adjustable in order to optimize the required shut-off tightness with the accompanying torque, for unidirectional or bidirectional operation.
• Replaceable seat without special tooling, dismantling or removing the valve from the line.
• A stainless steel disc edge resists against corrosion and avoids encrust build-up for consistent sealing.
• Dry shaft design.
• High strength stub shafts have full 1½ diameter penetration into disc-hubs with close tolerance-fit.
• Self lubricating sleeve bearings allow valve installation with the shaft horizontal or vertical.